Norco Eco-Stim NC89481, Instruction Manual, Page: 13 / 23

25 24
6.1 Turn on
When using device for the first time, open the battery cover and
load three new batteries (Please kindly review Section 5.1.1 for
the operating steps and schematic diagram).
Press the [ON/OFF/M] button to turn on the device, the LCD will
light up and then enter standby mode as shown below.
6.2 Select treatment mode
Based on your needs, press [ON/OFF/M] button to select the
treatment mode. The LCD displays as follows:
6.3 Select treatment program
Based on your needs, press [P] button to select the treatment
program. The LCD displays as follows:
6. INSTRUCTIONS FOR USE
6.4 Set program parameter
Press and hold [P] button to enter the setting mode.
1) In the program p1 to p6 of the TENS mode, and the program
p1 to p5 of the EMS mode, Press [+]/[-] button to adjust
treatment time.
The LCD displays as follows:
2) In the program U1 to U3 of the TENS mode, and the program
U1 to U3 of the EMS mode, press [P] button to adjust
pulse rate -> pulse width -> treatment time by setting
the parameter.
3) Press [+]/[-] button to adjust corresponding data.