28
Units Screen
This screen allows you to select available units. Disabling a unit will mean it cannot be selected from the
Target screen. This can be handy if for example all your measurements are in N·m
TIP: You will need to scroll this screen to see the full list of units
Serial Port
Here you can set up the configuration of the serial port Baud rate, Data bits, Stop bits, Parity and Flow
control.
As well as the format of the data the output can be configured. It is important that the serial port configuration
matched the configuration of the receiving device otherwise no data or corrupted data may be received.
TIP: You will need to scroll this screen to see the full list of settings
System Info
Here you can see details about your T-Box™ 2 system and perform firmware updates on the AnB modules.
Password
Tap to set, change or remove a password for the user interface. When set, the following activities are
password-protected:
- All system settings menus
- Creating/editing/re-ordering targets (users can set, but not modify targets)
To set a password, tap the password button and type in the new password. To change it, tap it again, enter
the password when challenged, and then enter the new password. To remove a password, do the same, but
do not enter anything in the New Password entry box. The UI will announce that the password was cleared.
