2D Goniometer SmartLead User Manual
13
(Rev D January 2020)
removed from the Ultium sensor (redetection is necessary
to revert to the use of the sensor’s EMG functionality). This
will prevent configuration errors leading to the inability to
collect a measurement. If an error message pops up when
starting a measure, and you are using SmartLeads, this is a
good first troubleshooting step (1. Redetect sensors in
hardware set-up; 2. Double check the configuration).
*
See Find My Sensor section below
Step 5
Once the Ultium system is
inserted, the muscle map will
appear to the left, and the EMG
channels and sensors will
appear below. The Ultium 2D
Goniometer SmartLead should
automatically appear, as
detected by the Ultium system (if
it does not
– refer to step 2).
To select the 2D Goniometer
SmartLead for use in a
recording, check the boxes next
to each goniometer channel (2D
Goniometer 1 X and 2D
Goniometer 1 Y).
Step 5
Continue with the measurement
setup as described in the
Noraxon Ultium
system’s
hardware manual.
5.6.2 Find My Sensor Feature
Find my Sensor allows the user to quickly locate a specified Ultium sensor while creating/editing a
MR3 configuration (refer to section 7 for guidance on how to create or edit a configuration). If one of
the stars (refer to the figure below) is clicked, the corresponding sensor will repeatedly blink light
purple in bursts of 3. If the topmost star is clicked, every sensor that is currently in the configuration
will execute the same blinking pattern.