41
6.6.1.1
Enter Sensor Serial Numbers
To enter a sensor in a one of the boom locations do the following.
1.
Make sure you are in manual mode, at the operating screen.
2.
Navigate to the "More ?" item in the Sensor Screen menu (see
Section 1 for help on getting to this screen). Press AUTO
(YES).
3.
Navigate to the boom section you put the sensor on, for example
"Right ?" if the sensor is mounted on the right hand boom.
Press AUTO (YES).
4.
Navigate to the boom location you mounted the sensor on, for
example RO for the right outer sensor. This screen will show
the previously installed sensor serial number (if any) as shown
in the table above. Use the " + " switch to toggle through a list
of available sensor serial numbers. If you wish to turn this
sensor off press " – ".
5.
When the desired serial number is shown, press AUTO (YES) to
confirm.
6.
Proceed to ROht menu item to check/calibrate the sensor’s
height reading (see next section). If you wish to return to the
operating screen, press and hold SETUP for two seconds.
6.6.1.2
Calibrate the Sensor’s Height Reading (Zero Height)
The Main Roll sensor’s "Sht" and "Cht" readings are exceptions to the
procedure described below. For more information on these readings refer to
the next section.
1.
Make sure the sprayer boom is unfolded and the sensors are
located over bare soil or gravel. Position the boom at a normal
working height. Do not conduct this procedure over standing
crop or tall grass/weedy areas.
2.
Using a tape measure, measure the distance from the bottom of
the spray nozzle closest to the sensor to the ground. Round this
measurement to the nearest half-inch.
3.
Navigate to the ROht menu item as described in the previous
section.
4.
If the currently displayed height reading is not correct, adjust it
using the +/- switch. The + switch will increase the reading, the
– switch will decrease the reading.
Summary of Contents for UC4 Total Control
Page 36: ...34 ...
Page 58: ...NOTES ...
