8
6
Operation
6.1
Basic UC4.5 Operation
Upon power-up a sequence of messages are temporarily displayed on the control panel LCD
screen. The system is ready for use once the run screen is displayed.
To access either the "SENSOR DISPLAY" (
) or "SETUP" (
) menus, the control panel
must be at the run screen.
Press the button corresponding with the menu desired.
Adjust the menu settings using the
buttons when the prompt is displayed.
After 30 seconds menu prompts will return to the run screen.
To return to the run screen press and hold
for two seconds.
New settings take effect once the run screen is displayed.
When the UC4.5 Height Control System is in automatic mode, arrows will appear on the
screen indicating the UC4.5 system is making a correction. Often the correction will be very
small and there may not be a noticeable change in boom position.
Figure 5: Run Screen
Changing to Automatic or Manual Mode:
From the run screen, press the control panel "AUTO" button (
) to put the system into
automatic mode. The run screen will show an "A" for each side of the boom to indicate the
system is in auto. Pressing the "MANUAL" button (
) or a sprayer joystick function will put
the system into manual mode. The run screen will show an "M" for each boom to indicate the
system is in manual mode.
A 45
A
LEFT BOOM
ARROW
AUTO / MANUAL
(Left Boom) or
MAIN LIFT ARROW
TARGET
HEIGHT
RIGHT BOOM
ARROW
AUTO / MANUAL
(Right Boom)
