41
used to enter the weight at which the set point will do its evaluation. This
value is channel dependent as far as the lb/kg units are concerned.
Error Messages
1 Invalid parameter number for calibration mode
2 Graduation size invalid
3 Decimal Position Invalid
4 Flag values must be 1 for ‘ON’ and 0 for ‘OFF’
5 Push to Zero Window must be 0-99
6 Zero tracking must be 1-99 or 100, 200, 300.
7 Only 1 will reset parameters
8 Only 1 will reset span table
9 Span exceeds maximum capacity or span to small
10 IZSM value can be 1 for ON and 0 for OFF
11 Test Weight units must be 0=lb or 1=kg.
12 Motion settle time out of range 1-100
13 Power on units may only be 0=lb, 1=kg.
14 Invalid Time entry HH.MM.SS
15 Invalid Date entry YY.MM.DD
16 Motion value is out of range
17 Press tare to increment span table, any other key invalid
18 Press tare to decrement span table, any other key invalid
19 Span table cannot be decremented passed 1
20 Parameter memory write error, indicator requires service
21 Parameter checksum error, Parameters have been lost.
22 Program check fault, indicator requires service
23 Invalid Serial Port speed setting.
24 Invalid Serial Port Parity parameter
25 Cannot increment Span Table any further
26 Entered offset larger than Capacity
27 Invalid String mode for com port
28 Power on Zero warning 0=Off, 1=On
29 Channel enable is 0=Off and 1=On
30 Only 1 will set the deadload
31 Sound Volume can be between 0-3
32 Keypress feedback can be 0=OFF or 1=ON
33 Invalid Com String mode parameter
34 Invalid Com Port Interface value
35 Scale must be at zero before entering a keyboard tare (see parameter 71)
36 Scale not ready to print
37 Channel 1 cannot be disabled
38 Invalid Print Select Function Number
39 *
40 Scale channel is not enabled
41 Pushbutton Tare is invalid (Over, Motion,or disabled)
