7
NookBox
Installation Guide
IR Universal Remote Control UPIC-5ZBS
Example:
a. Slide Switch 1,2,3,4,5 to ON will select all 5 appliance types.
b. Slide Switch 1 and 3 to ON to select Air Conditioner and Home Audio.
3. Press and hold both IR and ZigBee buttons and insert batteries to power up IR transmitter, do not release
the buttons yet.
4. Keep holding both IR and ZigBee buttons until IR LED turns on, then release the buttons
5. The IR transmitter will clear stored IR signal for selected appliance types,
the IR LED will flash continuously.
6. Slide all switches to OFF position to return to normal operation. The IR LED will turn off.
Installation
The IR Remote Control is designed to be mounted on wall. It can be mounted by either directly screwing the back
cover onto the wall, or by installing the rotational bracket first, then install the main body on the bracket. Please
refer to the IR Signal Coverage & IR LED Selection section below for information on IR signal transmission before
selecting the IR Remote Control’s mounting location.
Mounting the IR Remote Control
The IR Remote Control is designed to be mounted on wall. It can be mounted by either directly screwing the back
cover onto the wall, or by installing the rotational bracket first, then install the main body on the bracket. The IR
Eye should be pointed to the home appliance you want to control when the IR Remote Control is installed.
NOTE:
The Rotational Bracket is not included in standard shipping and is available upon request.
Direct Wall Mounting:
The back cover has 4 knockouts, where the plastic is thinner, for mounting purpose.
1. Open the cover and break through the 4 knockouts on the back cover.
2. Use the holes as template to drill holes in the wall, insert wall plugs if required.
3. Screw the back cover onto the wall.
4. Replace the front cover on the back cover.
Rotational Bracket mounting.
The Rotational Bracket has an adjustable head which can be attached to the IR Remote Control. After installing
the bracket on the wall, the user can adjust the angle of the head to change the direction IR Remote Controlis
facing.
1. The Rotational Bracket base has 2 mounting holes, Use the holes as template to drill holes in the wall,
insert wall plugs if required.
2. Screw the bracket onto the wall.
3. Hook the IR Remote Control onto the brackets using the holes on the back.
4. After completing installation, you can use a Philip screw driver to loosen the screw on top of the bracket,
then adjust the IR transmitter angle and tighten the screw to lock the bracket angle.
