6
NookBox
Installation Guide
IR Universal Remote Control UPIC-5ZBS
Example:
a. To select IR Signal 1, slide Switch 1 to ON, and Switch 2-8 to OFF.
b. To select IR Signal 2, slide Switch 2 to ON, and Switch 3-8 to OFF, ignore Switch 1 position.
1.
Select the IR Signal desired by adjusting dip switch. We suggest to be begin from IR Signal 1 by sliding Switch 1 to ON position to
select IR Signal 1.
2. Point your appliance’s IR remote control at opposite direction of the IR receiver to prevent the IR Receiver from receiving unwanted IR
signal.
3. Adjust the IR remote control to the setting you desired, then point the remote control at the IR Receiver, then press remote control
button to transmit the IR Signal
Example:
a. For air conditioner remote control, if you set the remote control to “Cool Mode, 18°C, Fan Speed Auto” and turn off the remote con
trol, then point the remote control at IR Receiver and press “ON.”
The IR Receiver will learn in “Cool Mode, 18°C, Fan Speed Auto” signal for the air conditioner
b. For television remote control, if you point the remote control at IR receiver and press ON/Off.
The IR Receiver will learn in ON/OFF signal for the television.
4. If the signal is received successfully, the IR LED will flash quickly, then turn off to indicating that IR Remote Control is storing IR Signal
data, then flash slowly again. If you accidently sent the wrong IR signal, point the remote control away to adjust setting, the point it at
the IR Receiver to retransmit signal again. The new IR signal will overwrite the old one.
5. After finish learning, change dip switch setting to learn another IR Signal, the repeat procedure from 2 to 4. We suggest to proceed
from IR Signal 1 to 8 by sliding dip switch 1 to 8 to ON position one by one
6. Repeat the process to learn in maximum of 8 signals for each appliance type.
7.
You can adjust your Dip Switch set 2 setting to select another appliance type.
Step 4. Exit IR Learn Mode
1.
After finish learning all IR signals, press IR button once to exit learning mode, then slide all switches to OFF position.
Testing
After complete learning the IR signals, follow instruction below to test transmitting IR signals.
1.
Do not enter IR Learn mode, adjust the Dip Switch setting accordingly to select the Appliance type and IR signal number as previous
ly learnt it.
2. Press the IR button once, the IR LED will flash quickly to indicate it is transmitting signal. If no signal is learnt in, the IR Remote Con
trol will not send any signal and IR LED will stay turned off.
3. Repeat procedure from 1 to 2 to test all learnt in IR signals.
4. After finish all settings, slide all switch to OFF position.
Clearing IR Data
To remove all IR signal learnt in for an appliance type, follow instruction below:
1.
Remove batteries to power down IR Remote Control.
2. Select the appliance type you want to remove using Dip Switch set 1 according to following table:
Slide more than one switch to ON will select multiple appliance type.
Switch 1
Switch 2
Switch 3
Switch 4
Switch 5
Switch 6
Appliance Type
ON
OFF
OFF
OFF
OFF
OFF
Type 1 (Air Conditioner)
OFF
ON
OFF
OFF
OFF
OFF
Type 2 (Television)
OFF
OFF
OFF
ON
OFF
OFF
Type 3 (Home Audio)
OFF
OFF
OFF
OFF
ON
OFF
Type 5 (Others)
