5
NookBox
Installation Guide
Siren Indoor
Function Overview
Siren Audible Performance
The siren produces a minimum of 104 dBA sound pressure at 1 meter on axis. It is programmable via two DIP switches (SW3 and SW4) for
four different siren durations:
1) 3 min.
2) 5 min.
3) 10 min.
4) 1 second (for testing)
•
The fourth position (1 second) is used for testing during installation.
•
For Burglar / Panic Alarm, the Siren emits continuous alarm sound.
•
For Fire / Water alarm, the Siren emits an intermittent alarm sound of 2-sec siren followed by a 1 sec interval,
cyclically during the programmed alarm duration.
•
The siren is silenced when either the programmed siren duration expires or the Control panel turns off the siren.
Previous Alarm Warning
If there has been an alarm while you were away, the Siren sounds alarm while the system is disarmed.
WARNING:
If the siren is activated for 3 seconds when you disarm your system, it is reminder you that there could be an intruder still in your
premises.
Tamper Protection
The Siren has tamper switches that protects the Siren from unauthorized cover opening. When the tamper switch is activated, the Siren will
activate alarm immediately and transmit tamper open signal to the Control Panel. If the user want to change Siren batteries or mounting
location, please make sure to disable the Siren tamper switch temporarily first before proceeding.
Audio Status Indication
While arming / disarming the system, the Siren uses different
methods to distinguish various 1statuses for the user, as listed
in following table:
<NOTE>
For those marked with asterisk (*), it means the Siren Audio indication
will be effected by the Confirmation ON / OFF. When setting Confirmation
to OFF, the confirmation sound will not be available.
Factory reset
The siren can be reset and memory contents cleared by following steps:
Step 1: Remove the learnt-in Siren from Control Panel, refer to the operation manual of your Control Panel for details.
Step 2: Open the top case of the Siren and the battery lid.
Step 3: Remove the batteries, and then press the tamper switch a couple times to discharge.
Step 4: Slide DIP SW 6 to ON position and restore the battery. The siren will produce a short confirmation tone.
Step 5: Slide the DIP SW 6 back to OFF position. The Siren returns to normal mode and the programming memory is clear.
Siren Audio
Arm/Home
1 beep*
Disarm
2 beeps*
Arm (Low Battery)
5 beeps
Disarm (Low Battery)
5 beeps
Arm (Tamper)
5 beeps
Disarm (Tamper)
2 beeps*
Previous alarm warning
3 secs beep
Tamper Alarm
Continuous beeps
Entry/Exit Sound
Count-down beeps
