7
NookBox
Installation Guide
Siren Indoor
Programming the Siren
Step 1 Locate the Control Panel “
Program Siren
” menu, Refer to Control Panel manual for detail.
Step 2 Make sure the Siren is in the normal operation mode.
Step 3 Set the “Siren Tamper”, “Confirm” and “Entry Sound” to ON or OFF at your discretion and click on those functions’ corresponding
buttons accordingly.
Siren Tamper
•
If set to “
ON
”, the Siren will ativate alarm when the tamper switch is triggered.
•
If it is set to “
OFF
”, the Siren will remain silent when the tamper switch is triggered.
<NOTE>
If the siren tamper is set as disabled (
OFF
), it will automatically revert to enable (
ON
) after about an hour if it is not switched back manually.
Confirm
•
If set to “
ON
”, the Siren will sound beeps when the system is armed or disarmed.
•
If set to “
OFF
”, the Siren will remain silent when the system is armed or disarmed.
Entry Sound
•
If set to “
ON
”, the Siren will sound beeps when the Entry timer is activated.
•
If set to “
OFF
”, the Siren will remain silent when the Entry timer is activated.
Step 4 Press Ok and then a short beep will be heard to indicate that the programming is successful.
Installing the Siren
Step 1 Temporarily disable Siren Tamper function from your Control Panel to avoid accidental alarm trigger.
Step 2 Find the location where the Siren is to be mounted.
Step 3 Use the 4 mountings holes as template to mark mounting location, drill holes and insert wall plugs if required.
Step 4 Screw the siren base onto the wall at mounting location.
Step 5 Replace the siren cover and secure the bottom screw.
Step 6 Enable Tamper Switch function again from the Control Panel.
Step 7 Check if the installation is successful by arming and disarming the Control Panel. Successful arming/disarming is indicated by the
table provided in
Audio Status Indication
.
<NOTE>
If 5 short-beeps are noticed while arming, it means the tamper is not correctly depressed when cover is closed. Check to ensure that tamper is properly
set and then test from Control Panel again.
Step 8 The installation is now completed.
Change the battery
Step 1 Disable the Siren Tamper function from the Control panel to avoid tamper alarm.
Step 2 Release the screws at the bottom of the siren and remove the siren cover.
Step 3 Open the battery compartment.
Step 4 Remove the old batteries; and press the tamper switch a couple times to fully discharge.
Step 5 Insert 4 new D cell alkaline batteries into the battery compartment and align the battery polarity correctly.
Step 6 The Siren will give sound beep when the last battery is inserted.
Step 7 Replace the battery compartment lid.
Step 8 Enable the Siren Tamper function from the Control Panel. The Siren will sound a beep to indicate the tamper protection is now
activated.
