6
NookBox
Installation Guide
Siren Indoor
Getting Started
Learning the Siren
Step 1 Release the screws at the bottom of the Siren and remove the front cover.
Step 2 Open the battery compartment cover and insert batteries.
Step 3 Locate the Function Switch Block; use a sharp object to slide Dip SW3 & SW4 on the Siren function switch block for your desired
alarm period.
Step 4 Put the Control Panel into the learning mode; refer to Control Panel manual for detail.
Step 5 Slide Dip SW1 on the Siren function switch block to ON position. The Siren will emit a short beep to indicate it is now in learning
mode. After 3 seconds, the Siren will send out a learning code and emit another beep .
Step 6 If the Control Panel fails to receive a learning code, slide Dip SW1 back to OFF and then ON position to enable Siren to enter the
learning mode again. Repeat the rest of the learning process.
Step 7 If the Control Panel receives the learning code, it will display Siren information accordingly. Refer to Control Panel manual to
complete learning process.
Step 8 After learning is completed, an acknowledgement signal will be sent to the Siren. When the acknowledgment is received, the Siren
will emit sound a short beep to indicate that learning process is successful.
<NOTE>
If the learning process fails, please remove the Siren from the control panel and repeat the step 3-7 again.
Step 9 Slide Dip SW1 on the Siren to OFF position. The Siren leaves learning mode. If Dip SW1 is not slid back to OFF position,
the Siren will automatically leave the learning mode one hour after it enters the learning mode.
Edit Siren Operation Area
Follow instruction below to change Siren Operation Area in the Control Panel
Step 1 Use the panel Edit Device function to change Siren area setting.
Step 2 Slide Dip SW1 on the Siren to ON, the Siren will emit a beep and flash LED 1 & 3 once.
Step 3 The Siren will send signal to panel after a couple second, to update setting info, it will emit a beep.
Step 4 When the Siren receives acknowledgement signal from panel, it will emit a beep again to indicate the setting has been updated.
Step 5 Slide Dip SW1 to OFF to return to normal operation. The Siren will emit a beep.
