Installation Guide
2. The sensors MUST be installed IN FRONT of
any grilles, plastic, mesh, or other materials. They
must have a clear and unobstructed view of the
road.
3. Sensors must be installed level, perpendicular
to the road surface. They must be pointed
straight ahead and not toed in or out.
4. Three sensors are provided; for a proper
installation, visually section the front bumper of
the car into three equal sections. Each sensor
should be responsible for covering approximately
one third of the bumper area.
5. Sensors can be mounted to the vehicle in one
of two ways - with the included snap-in brackets,
or with 3M adhesive tape. If the area on your
bumper where you are mounting the AL Priority
sensors is already perfectly
fl
at and level, you may
opt to use 3M tape to stick the sensors directly
to the bumper. If your mounting location is not
level, use the bendable metal brackets to attach
the AL Priority sensors.
6. Use the included bubble level to double-check
the quality of your installation. Ensure the AL
Priority sensors are level, pointed straight ahead,
and are not toed in or out.
7. Route the wires through the same
fi
rewall pass-
through that you previously ran the RC M front
antenna wires through.
8. Plug the sensors into the AL Priority Bridge box.
The middle AL Priority sensor MUST be plugged
into the F2 port on the ALP Bridge Box, the left
and the right sensors can be plugged into the F1
and F3 ports.
GPS Antenna
1. The GPS antenna requires a clear view of the
sky to work ideally, but it can also be mounted
behind plastic such as the underside of the top
of the dashboard. Other locations include on top
of the dashboard with 3M tape, on the back of
the rear deck lid, or magnetically mounted on the
roof.
2. After mounting the GPS antenna, carefully
route the wire back to the RC M CPU and plug it
into the port labeled “GPS.”
Display and Control Module
1. The Display and Control Module on the RC M is
designed with two components - a
fl
ush-mountable
base that provides power, and a magnetically
removable display/button module that can function
as a kill switch for the entire system.
2. It is important to mount the display in a location
that is both easy to see and touch while driving.
3. The power base of the display can be either
fl
ush
mounted or attached to a surface with 3M adhesive
tape. It is important that the base be mounted
securely so when the user removes the magnetic
display, the base station does not get removed as
well.
4. If
fl
ush mounting the display, be sure to protect
the area being cut with masking tape, and to
provide provisions for the USB cord to pass through
the opening and into the area where the RC M CPU
is located.
