RM-384
RF Troubleshooting
Issue1 Company Confidential Page 4-9
Copyright © 2008 Nokia. All rights reserved.
RF Call Test in Nokia CDMA L3 PST Fx.x
Context
Always start the troubleshooting procedure by running the RF Call Test in Nokia CDMA L3 PST. If a test fails, please
follow the diagram below.
If the phone is dead and you cannot perform the self tests, go to Dead or jammed device troubleshooting
in the baseband troubleshooting section.
Setup for RF Troubleshooting
Use the following steps to configure FTM mode for RF troubleshooting.
1.
Connect RF connector to a spectrum
2.
Put PWB on the module jig, connect data service cable between PC and Module Jig and connect a power
supply
3.
Launch Nokia CDMA L3 PST Fx.x Service Software and run RF Toolkit function
4.
The RF and Testing box appears
5.
Select “RF and Testing “.
6.
Press “Start RF Connection”
Figure 38 Display of Nokia CDMA L3 PST Service Software
