Hi5 VR Glove
Developer Guidelines
NOITOM corporation
Sep.2017 V1.1
Hi5 VR Glove Developer Guidelines
6
Step 6: Demagnetization (see
“2.5.3 Demagnetization”)
Step 7: Calibration (see
“5. Calibration Instructions”)
2.5.2 Pairing Gloves
Each set of Hi5
HAS ALREADY BEEN PAIRED
in the factory, so normally you
DO NOT
need to pair them again and the Glove will connect to the Dongle automatically. However,
if you mix different sets of Gloves up (the indicator lights of the Gloves and Dongle remain
in breathing status), you need to re-pair the Dongle and Gloves. The method is as follows:
Step 1. Dongle:
1. Plug in the Dongle into PC:
The indicator light will start to breathe.
2. The Dongle entering pairing mode:
Press and hold the button on the Dongle for 3 seconds (release when the indicator light turns on to a
solid state): The indicator light will slowly flash (flash at 1Hz). Now the Dongle is in pairing mode and
waiting for connection with the Glove/Gloves.
Step 2. Glove:
A. Pair of Gloves:
1. Turn on both Gloves:
The indicator lights on both Gloves will start to breathe.
2. Both Gloves entering the pairing mode:
Pressing and holding the buttons of both Gloves for 3 seconds(release when the 2 indicator lights
turn on to a solid state)
：
The 2 indicator lights will slowly flash (flash at 1Hz). Now the Gloves are in
pairing mode and they will connect to the Dongle automatically.
3. Now the Gloves and Dongle will enter working mode automatically (rapid flashing at
20Hz). The pairing operation for one pair of Gloves is now completed.
B. Single Glove:
1. Turn on the Glove: