Noblelift PTE15Q, Instruction Manual

Page: 19 / 27

17
Fault Code
When a fault code is generated, firstly all four battery indicator lights are on, then the first (most left)
battery indicator flashes and counts, then multiply this number by ten for the first number; then the fourth
(most right) battery indicator flashes and counts the times for the second number; Plus these two
numbers you will get the fault code.
Battery state of charge (SOC)
The battery's state of charge is indicated by 4 indicator lights. As the battery gradually discharges, the
battery indicator lights turn on in sequence. When the green light is on, SOC is 75%-100%. When the
blue light is on, SOC is 50%-75%. When the yellow light is on, SOC is 25%-50%, and when the red light
is on, SOC is 0%-25%.
e. Charging
 Before charging ensure that you are using an appropriate charger for charging the
installed battery and that all safety measures are taken into consideration.
 Before using the charger, please fully understand the instructions of the charger
instructions.

Always follow these instructions
 The room, where you are charging must be ventilated.

The exactly charge status can be only checked from the discharge indicator. To
control the status, the charging must be interrupted and the truck must be started.

Do not make attempts to charge the battery if it is impacted and the battery case is
damaged.
Fig.12: Battery charging
Park the truck at a dedicated secured
area with a dedicated power supply.
Lower the forks and remove the load;
Switch the truck off and connect the
charger power cord (18) to the socket of
power supply, and connect the charger
plug (19) to the charging socket (20) of
the battery. The charger starts charging
the battery.
If charging is completed, disconnect the
charger from the battery and the power
supply, then put the charger in the
designated pocket.