69
(c) Rub anticonosive oil on bared surface of piston rod and shaft ect.
(d) Cover parts prevent raining and wet.
(e) Startup vehicle at least once a month, install battery, clean the grease on piston and shaft,
startup engine and preheating, make vehicle move forward and backward slowly, meanwhile
operating hydraulic control for several times.
(f) In summer, do not park forklift on floppy furface such as asphalt ground.
(4) Operation after long time deposit.
(a) Take off dampproof cover.
(b) Cleaning pickling oil from bared parts.
(c) Cleaning impurity and water of hydraulic tank.
(d) Install full charged battery on forklift andconnect it.
(e) Check carefully before startup.
Ⅱ、
Using instruction of operating devices
1. Components,schematic diagram for operating devices
（
see following figure
）
1. overhead guard
2. rearview mirror
3. instrument
4. steering wheel
5. Multiple valve lever
6. Emergency stop switch
7.seat
8. Battery box cover
9. battery
10. traction pin
11. rear wheel
12. balance weight
13. rear combined lamps
14. electronic control
15. side plate
16
．
hood
17. accelerator pedal
18. Service brake
19. parking braking
20. tilt cylinder
21. fork rack
22.fork
23. lifting cylinder
24.mast
25. cornering lamp
26. head lighting
27. lift chain
