64
rigidity loading goods frame, or low lift height.
5. Transporting and loading for forklift
(1) Transportation of forklift
·Transporting with truck,Wedge forklift wheel or tighten forklift by rope to prevent it
moving during transportation.
·Pay attention to obey regulation of full-length, full-width, full-height of forklift during
transportation on traffic road.
(2) Loading and unloading for forklift
·Please use gangplank with enough length, width and intensity.
·Brake lorry firmly and wedge wheel.
·Gangplank shall be fixed on middle of carriage firmly, no greese on gangplank.
·Both height of left and right gangplank shall be same.
·Do not turn or transverse move during operating on
gangplank.
·When loading on lorry, in order to let forklift board on
simultaneously, please backing lorry slowly.
6. Preparation before driving
(1) Check position of direction switch handle
⑤
,and push it to
neutral position(N).
(2) Turn on ignition key
Catch hold of handle of steering wheel,then turn on ignition key
and keep it at “ON”position.
·Even after ignition key is turned to “ON”position,1 second is needed between brake
circuit starting to work and starting to move.
·If
gear
shift
lever
is
in
forwardposition“F”
or
backwardposition“R”,before turn ignition key to“on”position,push
gear shift lever to neutral position“N”
·Do notice that if step down accelerating paddle
suddenly,vehicle will probably accelerate suddenly.
(3) Tilting backward of mast
Pull backward lifting handle to lift fork
150-200mm upto ground,and pull backward tilting handle to tilt mast
backward.
(4) Operation of direction switch handle
⑤
Direction switch handle decide travelling direction
（
forward-backward
）
Forward F:push forward direction switch handle
Backward R:pull backward direction switch handle
(5) Loosen parking brake handle
Step down brake paddle
Let go parking brake handle forward entirely,catch hold of steering wheel with left hand,put
right hand lightly on steering wheel too.
7. Steer
(1) Starting up
Move food away from brake paddle and step down
accelerating paddle slowly,then,the vehicle will start to
move.
Acceleration rate is decided by how much
accelerating paddle is stepped down.
