45 OF 46
Here, you are nearly at the final assembly step of this Triangular Pergola.
These 3 (three ) pieces of
Roof Slats (G)
on the left are the last components to be
placed and affixed onto all 3 ( three )
Roof Support Joists
.
These 3 ( three ) pieces on the left of
Roof Slats
are to be bolted in at two places :
1. )
from the UNDERSIDE of the FRONT - Roof Support Joists, UPWARDS and
into the ROOF SLATS.
2. )
from the UNDERSIDE of the CORNER - Roof Support Joist. UPWARDS and
into the ROOF SLATS
Next, re-position the
Step Ladders to the RIGHT Pillar Panel
:
a. ) at the CORNER - Roof Support Joist area and
b. ) at the FRONT - Roof Support Joist area, as shown above.
2 ( two ) partners are on the Step Ladder shall receive and affix the
ROOF Slats.
The 3rd ( third ) partner shall hand the
ROOF Slats
to the 2 partners on the Step
Ladders.
Then place the
Roof Slat
into position.
With one hand apply pressure by
Pulling the Roof Slat 'groundwards'.
Use Screw (
①
) and Screw Driver (
⑫
), and drive the Screw
'skywards', as shown
above.
FULLY TURN IN ALL Screws at ALL points of fixture.
Repeat the same steps to affix the remaining 6 ( Six ) pcs of
ROOF Slats (G )
.
Ensure and
FULLY SECURE AND TIGHTEN ALL SCREWS at all Roof Support
Joists and Roof Slats.
Descend form the Step Ladders...
Then,
STAKE IN ALL the GARDEN STAKES ( not provided ) FULLY AND
COMPLETELY into the garden grounds.
The above completes the assembly for Your Triangular Pergola, and is ready for use.
Summary of Contents for TRIANGULAR PERGOLA
Page 37: ...37 OF 46 Step 25 E E 2 9 8 9 7 9 7 9 2 8...
Page 39: ...39 OF 46 Step 26 2 9 8 9 7 9 7 9 2 8...
Page 41: ...12 1 41 OF 46 G Step 27 12 1...
Page 44: ...12 1 44 OF 46 G 12 1...
