15 OF 46
Step 1
As the Pergola is tall, wide and heavy, we recommend :
1. ) That you identify and mark your ideal location where to place / position
this Pergola. By so doing, would mean minimal moving about of the partial
and or fully assembled Components and Pergola. Moving about the partially
assembled Components and or the assembled Pergola can bring about injury
and or damage(s) to the Pergola.
2. ) Unpack and place all parts on a Clean and Non-Marring Surface.
3. ) Place all parts in "group / bundle" as recommended above in the above
introduction.
Step 2
Place,
Upper Pillar (A1)
to
Lower Pillar (A2)
as shown above.
Affix
Upper Pillar (A1)
to
Lower Pillar (A2)
with the
Post Joint - Key (A3)
and
Screws (
⑥
)
. Use the
Allen Wrench (
⑨
)
, to affix the screws.
There are a total of
4 ( four ) Screws
to be affixed.
Repeat the same steps for the second piece of
Post Joint Key ( A3)
.
Repeat the same steps above for the remaining 2 ( two ) pillars
.
Upon completion,
FULLY SECURE AND TIGHTEN ALL SCREWS
, in this partially
assembled Pillar.
A3
A1
A2
A3
6
9
GROUND END
UPPER END
Summary of Contents for TRIANGULAR PERGOLA
Page 37: ...37 OF 46 Step 25 E E 2 9 8 9 7 9 7 9 2 8...
Page 39: ...39 OF 46 Step 26 2 9 8 9 7 9 7 9 2 8...
Page 41: ...12 1 41 OF 46 G Step 27 12 1...
Page 44: ...12 1 44 OF 46 G 12 1...
