8 Maintenance and Cleaning
NivuLink Micro - Rev. 02/13.11.2018
page 55
8.2.2
Customer Service Information
For the recommended annual inspection of the entire measurement system and/or
the exten-sive inspection after latest ten years contact our customer service:
NIVUS GmbH – Customer Service
Phone +49 (0) 7262 9191 - 922
8.2.3
Standard maintanance
Regularly check the following
•
that the NivuLink Micro is not mechanically damaged
•
that all joints and connections are properly sealed and not corroded
•
that there is no physical damage to cables
8.2.4
Charging the battery
CAUTION
Risk of injury and risk of material damage
−
Do not charge the battery on a combustible surface.
−
Be present while the battery is charging.
CAUTION
Material damage caused by using an incorrect charger
The battery can be irreversibly damaged if the wrong type of charger is used: the
cells can be drained or an explosion can occur, for example.
−
Use charger NLG0 LAD AP 5414 only.
Important Note
Batteries wear out and discharge over time. They also loose charge at high / low
temperatures as well as when they are used a lot.
Current transportation guidelines dictate that all batteries with an integral
rechargeable energy accumulator are shipped with a charge of max. 30%. If the
device uses an external charger (V IN) when is service, the battery will be
continuously charged by the charging regulator in the NivuLink Micro.
If no external charger (V IN) is available during production, the battery must be fully
charged before initial startup.
