Setting Parameters
page 63
rev. 00 / 12.04.2017
•
Fixed Value
This selection is conceived for permanently full pipes and channels. Level measure-
ment is not required for such applications. The constant filling level is set as fixed
value and then used by the system to calculate the flow rate.
This parameter can be used as support for initial start-up or for test purposes without
having level values available.
23.2.2 Definition of Measurement Ranges
A vertical coloured bar is indicated on the right-hand side of the channel graph depending on
the type and number of selected sensors. This bar specifies the working area of the individual
sensors using the according colour.
• Measurement range
Top: red
Centre: yellow
Bottom: green
• Number of sensors used
one sensor: solid green bar
two: combination green/red
Fig. 23-10 Selection of sensors and representation of measurement ranges
On to three coloured programming sections are indicated below the channel graph depending
on type and number of the selected sensors. The colour of these programming sections corre-
sponds with the colour of the vertical bar as well as the assigned sensors.
• Measurement range
Top: red
Centre: yellow
Bottom: green
• Number of sensors used
one sensor: solid green bar
two: combination green/red
