Warning: Do not use beans which were treated with additives like sugar or similar products during or
after the roasting process. This may cause damages to the grinder. The resulting repair costs are not
covered by the guarantee.
2.4. Turn on the appliance and fill the system
➔
Turn the appliance on with the On/Off switch (picture 1/H).
Please set the following basic setting prior to preparing your first coffee:
Set a language
➔
Turn the rotary to set your language.
➔
Press the rotary to confirm your setting.
The display shows “INSERT FILTER?’’.
2.4.1. Operate appliance
with
filter
The scope of supply includes a Claris filter. When using the filter, descaling your appliance becomes
less often as the filter softens the water.
➔
Turn the rotary to ‘YES’ and press the rotary so that the appliance recognises that a new filter has
been inserted.
➔
The display shows “INSERT FILTER’’.
➔
Empty the water tank (picture 1/F and 2) and carefully screw the filter with the installation aid at
the back of the measuring spoon (picture 4) into the corresponding mounting in the water tank.
Warning: Do not overwind or bend.
➔
Fill the tank with fresh water above the minimum mark (0,5 l) and insert it back into the appliance.
➔
Close the cover on the left side of the device again.
➔
Place a big enough container (at least 0,5 l) underneath the water outlet (picture 1/P) and open
the steam- hot water- rotary knob clockwise.
The system is now being rinsed. The display shows “FILTER RINSING’’.
➔
Wait until no water is coming out of the outlet after some time. Then, close the steam- hot water-
rotary knob anticlockwise.
The display shows “PLEASE RINSE’’.
➔
Press the rotary.
The display shows “SYSTEM RINSING’’.
When the appliance is heated, the display shows the main menu with the beverage symbols as a sign
of the appliance being ready for its use.
At the first preparation: If you are preparing coffee for the first time, the grinding chamber is still empty.
It is possible that the appliance is not preparing any coffee and that the display is showing “FILL
BEANS’’ after the first grinding process.
➔
Follow the notes on the display and, in this case, press the rotary once again.
The process is being repeated.
Information: If you use the appliance with filter and have programmed the system to “INSERT FILTER’’
“YES’’, the possibility to adjust the water hardness is cancelled. Internally, the water hardness is set
on level 1 automatically! Then, you have to descale your appliance less often - but always on request
and always with REMOVED FILTER.
After the supply of approximately 50 l of water, the effect of the filter is exhausted (Change filter see
point 3.1).
8
•
2. Set up
