We have found that using the
/dev/cu.[your device name]
works, and have verified
Step 1 working on the
/dev/cu.[your device name]
device. You may get an error
trying to use
/dev/tty[your device name]
.
Using higher baud rates in Windows and Linux does not appear to be an issue as of the
publication of this document.
7.4 Network Registration
If your Skywire is not registering on the network, ensure that you have the antenna
connected to the correct port on your Skywire and M1DK according to Section 2.2.4. In
addition, please make sure that you are setup to automatically register on the network
by checking the auto-attach settings in Sections 4.11 and 4.12. Make sure you are
getting an acceptable signal strength according to Section 4.13. Finally, make sure that
you typed the APN correctly according to Section 4.10.
If the Skywire does not automatically register on the network after about thirty (30)
seconds, check the status of the attachment by typing the following command:
AT+CGATT?
followed by the Enter Key, and you should see:
+CGATT: x
OK
where
x
is either
0
(not attached) or
1
(attached). If the result is
0
, type the command:
AT+CGATT=1
followed by the Enter Key, and the terminal should respond with:
OK
Return to Section 4.14 and continue from there.
PN 30192 rev 10
© NimbeLink Corp. 2018. All rights reserved.
23
