3xxxx
is the firmware version number to look for. Please compare that firmware version
with the version listed in Section 1.3, as well as in the firmware update application note:
If your version is older than the latest one available, please update the firmware using
the that guide.
4.10 Set Your APN
When you activate cellular service, an APN is assigned and must be used by the
modem to properly route traffic when using the network. Testing has been performed
with Verizon Dynamic APNs and Private Network APNs. Accounts activated through
NimbeLink (go.nimbelink.com) will be setup with the APN:
NIMBLINK.GW12.VZWENTP
To set this APN in the modem, type the following command:
AT+CGDCONT=3,"IPV4V6","NIMBLINK.GW12.VZWENTP"
followed by the Enter Key, and the terminal should respond with:
OK
4.11 Enable Cellular Functionality
To conserve power, by default cellular functionality is disabled. To enable cellular
functionality, type the following command:
AT+CFUN=1
followed by the Enter Key, and the terminal should respond with:
OK
This functionality will reset when rebooted. Therefore, this command will need to be
sent at each power-on.
If you would like to have the Skywire boot in
AT+CFUN=1
mode, issue:
AT+SQNAUTOCONNECT=1
followed by the Enter Key, and the terminal should respond with:
OK
This command is saved in non-volatile memory (NVM), and therefore only needs to be
issued once. To verify that this command is set, you can issue:
AT+SQNAUTOCONNECT?
followed by the Enter Key, and the terminal should respond with:
+SQNAUTOCONNECT: x
PN 30192 rev 10
© NimbeLink Corp. 2018. All rights reserved.
17
