5
NEPTUNE SB
1)
Options / model variants
Original instructions
CAUTION!
High-pressure water jets can
be dangerous if misused. The
jet must not be directed at per-
sons, animals, live electrical
equipment or the cleaner itself.
Wear appropriate protective
clothing and eye protection.
Do not direct the jet towards
yourself or towards other per-
sons in order to clean clothes or
footwear.
During operation of the cleaner,
recoil forces are produced at the
gunvalve and spray lance and,
when the spray lance is held at
an angle, a torque is also cre-
ated. The gunvalve and spray
lancemust therefore be held
fi rmly in both hands.
Do not use the cleaner when
other people without protective
clothing are in the working area.
Check that cleaning will not result
in dangerous substances (e.g.
asbestos, oil) being washed off
the object to be cleaned and
harming the environment.
Do not clean delicate par ts
made of rubber, fabric, etc. with
the 0° jet. Keep some distance
between high pressure nozzle
and surface in order to prevent
the surface from damage.
Do not use the high-pressure
hose for lifting loads.
NOTE
!
The maximum permissible work-
ing pressure and temperature
are printed on the high-pressure
hose.
Do not use the cleaner if the
power cord or high-pressure
hose is damaged.
Ensure adequate air circulation.
Do not cover the cleaner or oper-
ate it in inadequately ventilated
rooms!
Store the cleaner where
it will not be exposed to
frost or use antifreeze
liquid!
Never operate the cleaner with-
out water. Even brief shortages of
water result in severe damage to
the pump seals.
Water connection
This high pressure
washer/cleaner is
only allowed to be
connected with the
drinking water
mains, when an appropriate
backflow preventer has been
installed, Type BA according to
EN 1717. If the back flow pre-
venter hasn’t been supplied,
one can be ordered from your
dealer. The length of the hose
between the backflow preventer
and the high pressure washer
must be at least 12 metres (min
diameter 3/4 inch) to absorb
possible pressure peaks. Op-
eration by suction (for example
from a rainwater vessel) is car-
ried out without backflow pre-
venter. Contact your dealer for
suction set recommendations.
As soon as water has flown
through the BA valve, this water
is not considered to be drinking
water any more.
Operation
Keep cabinet and service door
closed during operation.
CAUTION!
Unsuitable extension cords
can represent a source of dan-
ger. Always unwind cord from
the reels completely to prevent
the power cord overheating.
Connectors and couplings of
extension cords must be water-
tight.
Extension cords are not recom-
mended, however if necessaray
refer to the following recom-
mendations:
Cord length
m
Cross section
up to16 A
up to 25 A
up to 20 m
(US: 30 ft)
(US: 50 ft)
(US: 75 ft)
ø1.5mm²
14 gauge
12 gauge
10 gauge
ø2.5mm²
12 gauge
10 gauge
not recom-
mended
20 to 50 m
ø2.5mm²
ø4.0mm²
Do not damage the power cord
(e.g. by driving over it, pulling or
crushing it).
Disconnect the power cord by
grasping the plug only (do not pull
or tug the power cord).
CAUTION!
Unsuitable fuels (e.g. gasoline)
must not be used as they can
explode and catch fi re.
Use clean fuel only, free of mois-
ture and contamination. Contact
your dealer for fuel source and
type recommendations.
If the machine is to be operated at
fuel stations or in other potentially
hazardous areas, the machine
may only be employed outside
the hazard areas defi ned in the
German „Technical Guidelines
for Infl ammable Fluids“ applica-
ble at the point of use due to the
potential explosion hazard posed
by the burner.
If the machine is to be operated
indoors, the local building regu-
lations must be observed for the
discharge of the exhaust fumes
into the atmosphere. Ensure an
adequate supply of fresh air.
If the machine is to be connected
to a fl ue gas stack, then local
building regulations must be ob-
served. We will be glad to provide
tips for connection systems, on
request.
CAUTION!
Beware of hot water and
steam discharge up to
150
0
C when operating in
steam stage
.
CAUTION!
Do not touch or cover the
exhaust. Risk of burns
and fi re.
