USER MANUAL
ENGLISH
SR 1300H B
146 1062 000(3)2007-02 A
15
BEFORE STARTING THE MACHINE
Make sure that there are no open doors/hoods and that the machine is in normal operating conditions.
If the machine has not been used after being transported, check that all the blocks used for the transportation have been
removed.
STARTING AND STOPPING THE MACHINE
Starting the machine
Sit on the driver's seat (38), then adjust the seat in order to reach a comfortable position by using the lever (73).
Unlock the knob (66) by pulling it, then tilt the steering wheel (65) in order to reach a comfortable position. After the adjustment,
release the knob (66) and slightly move the steering wheel to lock the inner fastener.
Sit on the driver's seat (38), insert the ignition key (68) and turn it to "I", without pressing the drive pedal (70), then wait (for a
few seconds) for the display (60) to turn on and the working hours to appear.
Check that the green warning light (63) turns on.
If the yellow (61) or red warning light (62) turns on, turn the ignition key to "0" and remove it. Charge the batteries (see the
procedure in Maintenance chapter).
NOTE
The seat (38) is equipped with a safety sensor, which allows the machine to be driven only when the operator is on the
driver's seat.
Disengage the parking brake by pressing the pedal (76) and disengaging the lever (69).
Drive the machine to the working area, by keeping the hands on the steering wheel (65) and pressing the pedal (70) on the
front side to move forward and on the rear side to move backward.
The drive speed can be adjusted from zero to maximum speed by increasing the pressure on the pedal.
Lower the main broom with the lever (74), then turn on the vacuum system with the lever (67).
Lower the right side broom with the lever (71).
If equipped, lower the left side broom with the lever (72).
NOTE
The brooms (10, 11, 12) can be lowered and lifted even when the machine is moving.
The brooms do not turn when they are lifted.
When the main broom is lifted, the vacuum system is not operating.
To sweep, drive the machine by keeping the hands on the steering wheel (65) and pressing the pedal (70).
Stopping the machine
To stop the machine, release the pedal (70).
To stop the machine quickly, also press the service brake pedal (76).
In case of emergency, press the emergency push-button (64) to immediately stop the machine.
To deactivate the emergency push-button (64), turn it in the direction shown by the arrow.
Turn the ignition key (68) to "0" and remove it.
Engage the parking brake by pressing the pedal (76), then engage the brake lock control lever (69).
1.
2.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
1.
2.
3.
