ENGLISH
USER MANUAL
14
146 1062 000(3)2007-02 A
SR 1300H B
USE
WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER
WARNING
CAUTION
CONSULTATION
–
–
–
–
While reading this Manual, the operator must pay careful attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if they are damaged.
BATTERY CHECK/SETTING ON A NEW MACHINE
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
or connected. The batteries must be installed by qualifi ed personnel only. According to the type of batteries
(WET or GEL), set the electronic board of the machine.
Check the batteries for damage before installation.
Disconnect the battery connector and the battery charger plug.
Handle the batteries with great care.
Install the battery terminal protection caps supplied with the machine.
The machine requires one 24 V battery, or four 6 V batteries in serial connection.
The machine can be supplied in one of the following confi gurations:
Batteries already installed and ready to be used
Batteries installed on the machine but without electrolyte
Without batteries
According to machine confi guration, proceed as follows.
Batteries already installed and ready to be used
Open the hood (13) and engage the hood support rod (37).
Check that the batteries are connected to the machine with the connector (25).
Disengage the support rod (37) and close the hood.
Insert the ignition key (68) and turn it to "I", without pressing the pedal (70).
If the green warning light (63) turns on, the batteries are ready to be used.
If the yellow (62) or red (61) warning light turns on, the batteries must be charged (see the procedure in Maintenance chapter).
Batteries installed on the machine but without electrolyte
Open the hood (13) and engage the hood support rod (37).
Remove the battery caps (24).
WARNING!
Pay attention when using sulphuric acid, as it is corrosive. If it comes in contact with skin or eyes, rinse
thoroughly with water and consult a physician.
Batteries have to be fi lled in a well-ventilated area. Wear protective gloves.
Fill the battery cells with sulphuric acid for batteries (density from 1.27 to 1.29 kg at 25°C) in accordance with the instructions
shown in the Battery Manual.
The correct quantity of sulphuric acid is shown in the Battery Manual.
Let the batteries rest and fi ll in with sulphuric acid in accordance with the instructions shown in the Battery Manual.
Charge the batteries (see the procedure in Maintenance chapter).
Without batteries
Buy appropriate batteries (see the Technical Data paragraph).
For the battery choice and installation, apply to qualifi ed battery Retailers.
Install the batteries, then set the machine according to the type of batteries (WET or GEL) (see the procedure in Maintenance
chapter).
Charge the batteries (see the procedure in Maintenance chapter).
a)
b)
c)
a)
1.
2.
3.
4.
b)
1.
2.
1.
2.
3.
4.
c)
1.
2.
3.
