44 - FORM NO. 56043094 / Captor
™
4300, 4800, 5400 / CR 1100, 1200, 1400
SQUEEGEE SYSTEM
SQUEEGEE MAINTENANCE
After each use, clean the squeegee tool and check the blades for damage. If the squeegee leaves water in the middle of its path or at both ends
of its path, it probably needs to be adjusted. Reverse or replace the blades if they are cut, torn, wavy or worn.
To adjust the squeegee:
1
Park the machine on a level floor, lower the squeegee and drive forward a short distance.
2
See Figure 1. Loosen the two Squeegee Adjustment Lock Nuts (A).
3
Turn the two Squeegee Adjustment Bolts (B) counter-clockwise for forward tilt or clockwise for backward tilt. Pull forward a short distance after
each adjustment to see if the rear squeegee blade touches the floor evenly across the entire width of the squeegee tool. Then re-tighten the
two Nuts (A). NOTE: Hold Bolts (B) with wrench while tightening Lock Nuts (A).
To reverse or replace the rear squeegee blade:
1
Unlatch the Rear Squeegee Blade Latch (C) and remove the (2) Wing Nuts (D).
2
Remove both Rear Straps (E) and the Rear Squeegee Blade (F) from the machine.
3
The squeegee blade has 4 working edges. Turn the blade so a clean, undamaged edge points toward the front of the machine. Replace
the blade if all 4 edges are nicked, torn or worn to a large radius.
4
Install the blade, following the steps in reverse order and adjust the squeegee tilt.
To reverse or replace the front squeegee blade:
1
Disconnect the Squeegee Hose from the squeegee tool.
2
Loosen the (2) Squeegee Levers (G) and slide the squeegee assembly off of the squeegee mount.
SERVICE NOTE: Depending on the position of the Squeegee Lever Handle (H), you may not be able to rotate the lever far enough to
loosen or tighten depending on which you are trying to do. In this case, simply lift UP on the Handle (H) and rotate the lever in the direction
necessary to acquire adequate turning space and then allow the lever to drop back DOWN into place on the hex. You can then either tighten
or loosen as needed.
3
Remove all of the Wing Nuts from the front squeegee blade strap.
4
Remove the strap and blade from the squeegee assembly.
5
The squeegee blade has 4 working edges. Turn the blade so a clean, undamaged edge points toward the front of the machine. Replace
the blade if all 4 edges are nicked, torn or worn to a large radius.
6
Install the blade, following the steps in reverse order and adjust the squeegee tilt.
revised 1/06
