FORM NO. 56043056 / ConvertaMAX™ 20/26 / BA 550/650 - 11
FUNCTIONAL DESCRIPTION OF CONTROL BUTTONS:
Solution Tank Fill (1) – Open to fill the solution tank, use non-foaming chemicals only (capacity 20 gal. / 75 liters)
Recovery Tank Cover (2) – Point of entry for waste water into tank. Also houses float ball which shuts off vacuum port to vac motor
when tank is full.
Squeegee Lever (3) – This lever controls both the squeegee and the vacuum motor. There are three positions: OFF, vacuum ON
and vacuum ON with the squeegee on the floor.
*
Off
*
Vacuum ON
This position lifts the squeegee slightly while leaving the vacuum turned on. This can be used for backing up during scrubbing,
or supplies vacuum for cleaning remote areas using an attachment.
*
Vacuum ON with the squeegee on the floor
This position is for picking up solution while scrubbing.
Brush Raise / Lower Pedal (4) – Located at the right rear corner near the floor, this pedal is used to raise or lower the brush head.
Drive Paddle (5) – Located on top at the rear of the machine, the operator can make the machine go forward by pushing forward
on it, or reverse by pulling backward on it. The speed is variable depending on how far forward or backward the paddle is moved.
When the brush head is in the “DOWN” position, the brushes and solution will operate when the drive is engaged in either direction,
but will stop after the machine is stationary for 1 second.
Solution Drain Hose / Level Indicator (6) – Used to empty the solution tank and show current level of solution in tank, graduations
are marked on the side of the solution tank next to the hose.
Recovery Drain Hose (7) – Used to empty the recovery tank.
Squeegee Adjustment Knob (8) – Used to adjust the tilt of the squeegee. Turn knob clockwise to tilt the squeegee backwards and
counter-clockwise to tilt it forward.
Squeegee Blade Latch (9) – Holds rear squeegee blade and straps in place, release to replace rear blade.
Squeegee (10) – Picks up solution after scrubbing.
Battery Charger Connector (11) – Plug battery charger into this port to charge batteries.
Battery Fuel Gauge (12) – Shows current state of charge of batteries.
Hour Meter (13) – Displays number of hours machine has been used.
Solution Switch (14) – This switch is used to select the mode of operation for the solution system. There are 3 modes of operation
for this system. The modes are OFF, ON, MOMENTARY ON. Following is a description of each mode and how they are selected.
OFF: In this mode the solution flow is turned off.
ON: In this mode the solution flow will be turned on whenever the Drive Paddle (5) is in forward or reverse mode and the brush head
is down. The solution flow will be turned off otherwise.
MOMENTARY ON: – Solution can be dispensed by pressing and holding the solution button. Solution will be dispensed for as long
as the button is held. This is for pre-wetting the floor prior to scrubbing.
KNOW YOUR MACHINE
revised 9/01
