58
- FORM NO. 56043115 - 34 RST
Squeegee System
Caster Wheel Removal
1. Turn the key switch off and disconnect the battery pack.
Warning!
Never work under machine without safety stands or blocking to support the machine.
2. Drain both the solution and recovery tanks. Remove the squeegee assembly and have the scrub brush deck in
the up (stored) position with the scrub brushes installed.
3. See Figure 4.
Place Wood Blocking
(H)
in front of the drive wheels to prevent the machine from rolling.
4. Jack the machine in the location shown until the caster wheel is approximately 1” off the ground.
5. Place Blocking
(I)
under the chassis tab as shown.
6. Remove the (4) Screws, Nuts and Washers
(J)
then remove the Caster Assembly
(K)
.
7.
Reinstall in reverse order.
FIGURE 4
