53
- FORM NO. 56043115 - 34 RST
Recovery System
Removal and Installation
Vacuum Motor Removal
1. Drain the Recovery Tank
(A)
using the drain hose.
2. Turn the key switch off and disconnect the battery pack.
3. Swing open the recovery tank and disconnect the vacuum motor harness connector.
4. See Figure 5.
Carefully pull the Acoustical Foam vacuum exhaust hose
(B)
out of the P-Clamp
(C)
on the
Recovery Tank
(A)
.
5. Remove the (4) Phillips Pan Head Screws
(D)
and Flat Washers
(E)
holding the Vacuum Motor Shroud
(F)
to
the bottom of the Recovery Tank
(A)
, then remove the Vacuum Motor Shroud
(F)
.
6. Carefully remove the Vacuum Motor Assembly
(G)
and attached Acoustical Foam vacuum exhaust hose
(B)
from the Recovery Tank
(A)
.
Note:
Take care not to lose the three Vibration Mounts
(H)
.
7. Inspect the condition of the vacuum motor Gasket
(J)
, and the gasket on the inside of the Vacuum Motor
Shroud
(F)
.
8. Make service repairs to the vacuum motor and reinstall by following the above steps in reverse order.
FIGURE 5
