55
- FORM NO. 56043115 - 34 RST
Squeegee System
Squeegee System
Maintenance
Squeegee Lift Linkage Adjustment
See the
Know Your Machine
section in this manual. The squeegee pick-up tool is raised and lowered manually by a
rear control panel mounted Lever
(17)
.
Squeegee Lift Lever Adjustment
The squeegee tool’s storage and operating positions are adjustable. To adjust the squeegee position:
1. Lower the squeegee assembly to the floor.
2. See Figure 1.
Note that the squeegee mount weldment has three Mounting Holes
(A)
for changing the up /
down squeegee positions.
3.
Remove the Nyloc Nut
(B)
from the Hex Head Screw
(C)
, then remove the Hex Head Screw
(C)
, flat Washer
(D)
, Cable Bushing
(E)
and attached cable assembly from the squeegee mount weldment.
4. Reinstall in the Hex Head Screw
(C)
, flat Washer
(D)
Cable Bushing
(E)
and attached cable assembly into the
appropriate hole to raise or lower the squeegee positions as needed, then reinstall the Nyloc Nut
(B)
.
5. Make sure that the squeegee lift cable has ample free play when the squeegee is lowered.
Note:
This allows
the squeegee assembly the correct amount of up and down movement to allow the squeegee to “float” so the rear
blade remains on the floor surface through normal adjustments and wear.
FIGURE 1
