21
W
A L L
M
O U N T E D
P
R O G R A M M A B L E
I R K
E Y P A D
S
Y S T E M
Programming the Sequence
1. Press the PROGRAM button. The PROGRAM
LED, the IR/SEQ LED and the PAGE LED light
up red.
2. Press the IR/SEQ key to select Sequence
Programming mode. The IR/SEQ LED lights
green, the TRIG LED lights red, while the
PAGE LED remains lit.
3. Select the page on which the key that will trig-
ger the sequence resides. Select the pages by
pressing one of these keys: any of the six
SOURCE SELECT keys (the Source Pages), a
normal press of the POWER Key (the System
Page) or by pressing and holding the Power
Key for more than 1 second (the Press and
Hold Page). In our example, you would select
the System Page by pressing the POWER Key.
4. Press the key (on the page you just selected)
which will trigger the sequence. In our exam-
ple, you would select the “Tuner” Source
Select key. The TRIG LED turns off confirming
that you have selected the trigger key for the
sequence. The PAGE LED lights, prompting
you to select the page of the first command
in the sequence
5. Select the page of the first command. In our
example, the first command is to select the
Tuner input of the receiver. This command is
located on the System page which resides
under the POWER Key. The KEY LED lights,
prompting you to select the key of the first
command.
6. Press the key which issues the first command. In
our example, you would press the TUNER Key
(issues the Tuner Input command to the pre-
amp/receiver). The PAGE LED lights, prompt-
ing you to select the Page of the next com-
mand in the sequence.
7. Repeat steps five and six, until all of the steps in
the sequence are programmed.
8. Repeat steps 2-7 to program additional source
components.
9. To exit the Program mode, press the PROGRAM
button twice (the PROGRAM LED will go out).
Erasing a Sequence
If you make a mistake, you can erase a sequence
anytime by following these steps:
1. Press the PROGRAM button. The PROGRAM
LED, the IR/SEQ LED and the PAGE LED light
up red.
2. Press and hold the ERASE button until the
prompt LED’s light up, then release. The PRO-
GRAM LED begins to flash, warning you that
you are about to erase.
3. Press the IR/SEQ button, then the trigger Page
key, then the trigger Key.
DS00154A/IntelliPad 2/5/99 4:32 PM Page 9
