In case of installation errors an exclamation point/arrow appears on the LCD screen. It happens in two cases:
1. Input signals (external BS) are weak.
It can happen that even with a weak signal the amplifier works well. In this case, nothing should be done. Just ignore
a flashing exclamation point. However, if the indoor coverage is still very low, it will be necessary to adjust the
position of the outdoor antenna so that it can pick up a stronger signal. For that, try 3 possible solutions:
Solution 1. Direct the outdoor antenna to provider’s nearest base station.
Solution 2. Change the position of the outdoor antenna. Try to put it as high as possible.
Solution 3. Reinstall the outdoor antenna trying to avoid obstacles between the antenna and provider’s base station.
2. The separation between the two antennas (outside and inside) is not sufficient.
This can cause interference between antennas and, as a result, the device will reduce the device gain. The output
signals will, therefore, be very weak. To avoid the risks of this type of malfunction, make sure not to put the 2
antennas too close to each other, (D = 10-20 m) and never to orient them face to face, ideal would also be that they
are not in direct vision (use of a mineral or metallic obstacle, wall, ceiling, slab, etc.), and they aim opposite
directions, or at least frankly different.
Does my signal booster work if its LCD screen is switched off? What does Sleep mode mean?
The signal booster enters into Sleep mode only when you don’t use it. During Sleep mode only the LCD display turns off, while the
amplification system keeps on functioning. This function allows saving energy. In case you need to see information on the screen,
just push any button.
Can I use 1 indoor antenna if I don’t need 2?
Yes, you can use only 1 indoor antenna if the distance between both indoor antennas in your case cannot exceed 5m. However, if
you can install the indoor antennas at the distance exceeding 5m or create some obstacles like walls between them, we
recommend you using 2 indoor antennas for more effective signal distribution and larger coverage.
System Test
Check whether the coverage is good
1. Take a test with a mobile phone or a data card (engineering mobile phone is preferred). If the signals in most areas have
not been improved, please check recommendations below again:
- Weak input signal leads to low output power. To increase input signal power level, change the direction of the outdoor
antenna or its installation position or replace it for an antenna with higher gain.
- Check whether it is necessary to use additional indoor antennas as barriers block signal penetration; also check
whether the repeater’s power is enough; please install extra indoor antennas or replace the repeater for another model
with higher power level.
2. If the signals in small parts of the area have not been improved, please check the following:
- Check whether the indoor antenna is installed correctly or not; you may try to change the antenna location to improve
coverage.
- Check if it is necessary to adjust the direction of the indoor antenna.
- Check whether it is necessary to add one or more antennas to enhance the coverage in special areas.
Summary of Contents for LCD-500GD
Page 7: ......
