Nikon HVBTR-1200, Instructions For Use Manual

Page: 7 / 30

- v -
CAUTION
1. Confirm the input voltage
• Before plugging in the power cord, confirm that the input voltage indications on the host
computer and the display (located on labels near the power receptacles) match the supply
voltage that is being used.
If the input voltage is not identical to the supply voltage, do not attempt to connect the
power but contact your nearest Nikon representative. Using the incorrect supply voltage
could cause a malfunction, fire, or electric shock.
• The input voltage for the VMA-2520 automatically switches within 100 - 240 V~, 50/60Hz.
The power supply receptacle is located on the rear of the controller.
• Always plug the power cords for this system (including the VMA-2520, the computer, and
the computer display) into a grounded three-conductor outlet. Improper grounding can
result in electric shock or abnormal operation.
• Always be sure to turn OFF all of the power switches before plugging in the power cords.
2. Do not touch moving parts
Do not touch any moving parts, as these parts can trap your hands or fingers.
3. Cautions concerning heat from the controller
Note that the internal parts of the controller are extremely hot during and immediately after
equipment operation.
• Do not bring highly flammable materials (gasoline, benzene, paint thinner, alcohol, etc.),
cloth or paper near the controller. Doing so could start a fire.
• There are ventilation openings for a cooling fan on the rear of the controller. In order to
allow the adequate dissipation of heat, install the controller so that there is an open space
of at least 20 cm between the rear panel of the controller and the nearest wall. Do not
obstruct the ventilation openings on the front of the controller.