Niko 10-850, Manual, Page: 61 / 80

10-850
61
nv Niko sa Industriepark West 40, BE-9100 Sint-Niklaas, Belgium — tel. +32 3 778 90 00 — fax +32 3 777 71 20 — e-mail: support@niko.be — www.niko.eu EN
6. OPERATION AND USE
6.1. Call from a telephone to the telephone interface
After a call to the telephone interface, you can perform the following functions using the keypad:
Action Key combination
call external unit 1 (external unit with external unit address 0)
2 (external unit with external unit address 1)
3 (external unit with external unit address 2)
call internal unit 4 (set serial number, see section 5.13.)
5 (set serial number, see section 5.13.)
6 (set serial number, see section 5.13.)
activate door opener relay 7 (first call an external unit)
activate light relay 8 (first call an external unit)
call external unit 0 XX (XX = external unit address between 10 and 63)
activate actuator output
✱ ✱
activate relay for flush mounting (10-837) or
DIN-rail relay (10-830)
✱ X
where:
- X = number from 0 to 9
1
1
0 = control function 10, 1 = control function 1 … 9 = control function 9
6.2. Call from an external unit to a telephone
In order to initiate a speech connection with the external unit, you must either pick up the receiver or you must pick up the receiver and also press key
7, depending on the setting (see section 5.6.). After that, you can perform the following actions:
Action Key combination
activate door opener relay 7
activate light relay 8
interrupt a connection1 9
activate actuator output
✱ ✱
activate relay for flush mounting (10-837) or
DIN-rail relay (10-830)
✱ X
where:
- X = number from 0 to 9
2
1 If you do not press key 9 to interrupt the connection, a busy signal will be heard at the external unit for the remainder of the conversation time.
2
0 = control function 10, 1 = control function 1 … 9 = control function 9
7. TROUBLESHOOTING
Errors are visually and acoustically displayed:
• After a call to the telephone interface, you will hear an error tone three times (at the telephone) after which the connection is interrupted.
• The red status LED on the telephone interface keeps flashing or remains illuminated (see table below). The visual error message on the
telephone interface remains active until the error is remedied.