29
FR
10-845
13.2. Conserver la télécommande
Après son utilisation, conservez la télécommande IR à proximité de la mémoire vidéo, à un endroit uniquement accessible aux techniciens.
13.3. Remplacer la pile
La télécommande IR nécessite 1 pile bouton CR2025 (DC 3.0 V).
Enlevez la plaquette du logement de la batterie, à l'arrière de la télécommande IR.
Veillez à ce que la polarité de la pile corresponde aux m/- figurant dans le logement de celle-ci.
Mettez la pile en place.
Remettez la plaquette en place.
13.4. Mise au rebut des piles
Ne jetez pas les piles usagées dans les déchets ménagers normaux. Portez les piles à un point de collecte de piles usagées.
14. DÉRANGEMENTS
Si la LED rouge clignote en permanence et qu’une séquence unique de tonalités retentit, cela signifie qu’une erreur s’est produite. L’indication visuelle de l’erreur
reste active jusqu’à ce que l’erreur soit corrigée.
Erreur / problème / panne
Causes
Solutions
La LED rouge clignote.
Signal d’erreur :
La carte SD est manquante, défectueuse
ou pleine.
Placez ou remplacez la carte.
La LED rouge clignote.
Signal d’erreur :
Les conducteurs a et P ont été permutés
ou sont en courtcircuit.
Permutez les conducteurs a et P ou faites disparaître
le court-circuit. La LED s’éteint.
La LED rouge clignote.
Signal d’erreur :
Le conducteur a n’est pas raccordé
ou n’est pas alimenté.
Raccordez le conducteur a ou M
ou rétablissez le courant. La LED s’éteint.
La LED rouge clignote.
Signal d’erreur :
Le bouton de réinitialisation se bloque
(enfoncé pendant plus de 15 sec.)
Relâchez le bouton de réinitialisation. L’appareil
revient en position de repos.
15. NETTOYAGE
ATTENTION ! Dégâts à la surface de l‘appareil.
Les produits d’entretien agressifs et abrasifs endommagent la surface.
N’utilisez pas de produits d’entretien agressifs ou abrasifs. Éliminez les saletés tenaces à l’aide d’un produit d’entretien à pH neutre.
16. MISES EN GARDE CONCERNANT L‘INSTALLATION
• L’installation doit être effectuée par un installateur électro professionnel et dans le respect des prescriptions en vigueur.
• Ce mode d’emploi doit être remis à l’utilisateur. Il doit être joint au dossier de l’installation électrique et être remis aux nouveaux propriétaires éventuels. Des
exemplaires supplémentaires peuvent être obtenus sur le site web ou auprès du service support de Niko.
• Il y a lieu de tenir compte des points suivants pendant l’installation (liste non limitative):
- les lois, les normes et les réglementations en vigueur.
- l’état de la technique au moment de l’installation.
- ce mode d’emploi qui stipule uniquement des dispositions générales et doit être lu dans le cadre de toute installation spécifique.
- les règles de l’art.
Ce produit est conforme à l’ensemble des directives et règlements européens applicables. Le cas échéant, vous trouverez la déclaration CE de conformité
relative à ce produit sur le site www.niko.eu.