EN
50
10-845
ATTENTION! Damage to the device.
If the central screen memory 10-845 is the only or last device at the end of a bus video line, the terminal resistor J1 must remain attached
(position ON, see nameplate). If not, remove the terminal resistor J1.
Ensure the installation is completely connected. Mount all components.
Connect the voltage.
Switch on the mains voltage.
Ensure that the SD card indicated on the nameplate is in the lock. The SD car only serves to save all configuration data and images. It must
always be in the device. Only use the included SD card.
8. CONFIGURATION
8.1. Configuration options
Function
manual
IR remote control
Niko Configuration SW
Set the operating mode
–
x
x
Set delay time for automatic recording
–
x
x
Set number of images for the automatic image series following a door call
–
x
x
Set break between recording of images in an image series (1 to 20 s)
–
–
x
Set video ExtU border for automatic recording
–
x
x
Encryption for image storage ON / OFF
–
x
x
Load factory settings
x
x
x
Setting date / time
–
x
x
Change master code
–
x
x
8.2. EFH and basic mode: setting function key of internal unit
EFH and basic mode: setting function key of internal unit
8.3. Factory settings
The device is equipped with an SD card, in which the following default settings are saved:
Operating mode
0 = EFH mode
Delay time for automatic recording
1 s
Number of images for the automatic image series following a door call
1
Video ExtU border for automatic recording
Images of external units with video ExtU border ≤ 31 are recorded
31.
Encryption for image storage
1 (activated)
Date format
0 (DD.MM.YYYY)
Master code
Serial number
Control button for brightness
0 dB (to left mark)
8.4. Loading factory settings by pressing reset key
When factory settings are loaded, all images are deleted. The master code and all the values set by you can be reset.