EN
38
10-491-01
6.2. Mounting instructions
ATTENTION!
• The video transmitter is equipped with thermal protection. It switches off the output voltage in case of high load.
• Pay attention to the climatic conditions. Ensure proper ventilation.
• The device will cause the device to switch off. Take the appropriate steps to prevent water from seeping into the device.
6.3. Connection of two-wire video transmitter
6.3.1.
Connecting wires
Connection terminals
Wire cross-section
Diameter of wires
Video and bus
0.07 - 1.5 mm
2
0.3 - 1.4 mm
Video input (coax)
0.07 - 2.0 mm
2
0.3 - 1.6 mm
Max. number of wires per terminal contact: 2 x 0.8 mm, 3 x 0.6 mm.
• Extra conductors can be connected using aid terminals.
• Only use connection wires from the same material and with the same diameter in a terminal contact.
6.3.2.
Preparing and connecting camera cord
To connect a camera device, the cord must be prepared as follows:
▶
Cut off the video connector.
▶
Strip the conductor and the outer conductor.
▶
Twist the outer conductor.
▶
Connect the conductor:
- conductor to terminal
- outer conductor on terminal .
