EN
36
10-491-01
Mount the camera on an even surface, using the included screws and plugs.
▶
On the indicated locations, drill a hole in the wall for the plugs. Make use of
the drilling template.
▶
Loosen the three small hexagonal screws on the housing ring of the dome,
using the included hexagonal key.
▶
Remove the dome. Important: the dome is connected to the camera holder
by a protective band.
▶
Tighten the camera holder with 3 screws.
▶
Connect the BNC connection cable and the power supply cable to the video
transmitter (see image below Connecting the dome camera).
5.4. Connecting the dome camera
Notes
ATTENTION!
If the connection conductors on the video transmitter are switched, the camera might break.
Instead of the included BNC connection cable, a longer cable (RG59 of RG179) may also be used.
10-491-0
1
tw
eedraadse video
ze
nder
V
V2 V1 M P b a
12V
Camera
Video IN
Video
OUT
Dome camera
Two-wire video transmitter
10-498
BNC connection cable
Power supply cable
for the camera.
black
red
Image 3: Wiring diagram dome camera with two-wire video transmitter.
Further in this product information you can find how to connect the two-wire video transmitter to the video system.
