27
■
Operating Method
●
Before starting cutting operation increase the throttle to
full speed. Operating the cutter at lower speeds reduces
the tension of the nylon cutting line, resulting in lowered
cutting effi ciency.
●
While swinging your body from side to side, cut the
grasses from the right side to left side.
The cutting head or blade rotates counterclockwise.
When a cutting head or blade cuts some articles from
the left to the
right, the cutting head or blade turning at a
high speed could touch hard, uncuttable and heavy fi xed
articles such as stones, trees, stakes and concrete, and
then the cutting head or blade could be thrust towards
unexpected directions.
●
Keep the right leg ahead of the left leg. Always step
forward with your right leg. If you step forward with your
left step fi rst, there is a risk that your left leg is cut with
the cutting head or blade.
●
Appropriate cutting range is as follows :
Cutting-line head :
12:00 o’clock position
Grass cutting steel blade : 10:00 to 11:00 o’clock position
(as shown in the fi gure to the right)
■
Prohibited Matter
●
Do not hold the trimmer/brush cutter on your left side.
Note
●
This trimmer/brush cutter is designed for the
operation with it held on the right side of the
operator.
●
Do not operate holding the trimmer/brush cutter
higher than your waist.
●
The line length is controlled by the cutter on the grass debris shield.
Never remove the line cutter or grass debris shield.
Doing so will cause the line to extend too far, which will overload and damage the clutch. Clutch damage
due to overload is not covered under warranty.