4
INSTALLATION AND WIRING INSTRUCTIONS
Remove the inset back mounting box from the luminaire. Fit the inset back mounting box onto the wall and tighten
the screws at a height that ensures adequate coverage of the area by the infrared detector. The minimum
installation height is 2 meters. And the maximum height is 3 meters.
*Please make sure the voltage and polarity are correct before connection. Incorrect voltage may
cause electric shock. If you are not sure, please contact your retailer.
NOTE: DO NOT REMOVE THE SECURING TAPE ON THE FITTING UNTIL THE UNIT IS
FULLY INSTALLED.
WIRING INSTRUCTIONS
Feed the cable through the back mounting box and bush
the cable entry to avoid abrasion to the cable.
Connect the earth wire to the connector opposite the
green/yellow cable.
Connect the red phase conductor active to the connector
opposite the brown cable and tighten the screws.
Connect the blue neutral conductor to the connector
opposite the blue cable and tighten the screws.
Check that all connections are correct and tight, as any
misconnections will damage the detector.
Re-fit the fitting to the back mounting box.
h
