6
OPERATION
1. Insert the plug to activate the light, the light is now under Test mode: light works on day and night
NOTE
: Allow for approximately 30 seconds warm-up time before the sensor resumes normal activity.
2. To test, walk through the sensor’s detection area.
3. Movement will activate the sensor and turn the light on; the light will turn to the detected zone automatically.
4. After the light is activated,
keep out of the detection area
and the light will switch off automatically after
light up time (30/60 seconds). The light will be activated again when detecting any movement.
If there is continuing movement in the detection zone, the light will stay on until movement ceases. (After
light up time)
LAMP REPLACEMENT
To isolate the unit, first switch off the unit from the mains power. Allow bulb to cool before attempting to
remove it. Unscrew the lamp cover and take the old lamp out and replace with a new one, close the lamp
cover and tighten the screws.
WARNING:
This fitting will become hot when in use. Allow bulb to cool before touching.
CLEANING
•
Before Cleaning make sure that the power is cut off and allow to cool before commencing.
•
Care must be taken while cleaning to avoid scratching the fitting and glass. A soft cloth or a fine hair brush should
be used with a non-abrasive cleaner.
DO NOT use solvents or abrasive cleaners on any part of the Nightwatcher.
NOTE: THE INTELLIGENT MOTION SENSOR TRACKING LIGHT IS DESIGNED TO ILLUMINATE
WHEN THE DETECTION AREA IS ENTERED BY A PERSON AND WILL DETECT A MOVING
HEAT SOURCE. THERE IS NO GUARANTEE IMPLIED THAT IT WILL PROVIDE TOTAL
SECURITY OR PREVENT ILLEGAL ENTRY.
