Nidek Medical LEX-DRILL, Service Manual

Page: 71 / 94

LHM2A*RDA001A/E
7 - 29
2. Check holes 1 to 7 to find one where the 0.0 degree and 30.0 degree holes appear as one
viewed from the lens front, as the figure indicated with A below. If the hole as A is found,
change the Front surface offset parameter value.
3. <When the hole as A is not found>
For the hole as B, decrease the Front surface offset parameter by 0.6, drill a lens again, and
perform adjustment.
For the hole as C, increase the parameter by 0.6, drill a lens again, and perfrom adjustment.
1) Display the Parameter screen. Select
“Parameter Setting” and display “Drill
Parameter 13/15” (see 7.5.1).
2) Press to highlight “Front surface
offset“ and change the set value with
or
.
4. The compensation value is 0.0 for hole 4. If
the holes drilled at the two angles are aligned
in the hole 4 position, adjustment is proper.
*For example: When hole 6 is optimum,
decrease the Front surface offset parameter
by 0.2.
Hole No. Compensation value
Ԟ
ԝ
Ԝ
ԛ
Ԛ
ԙ
Ԙ
Compensation value for each hole
Hole shaft axis
Angle 0.0
Lens front surface
㧙 㧙 㧗
# % $
Angle 30.0
#
$
㧗
㧙
%
Hole appearance
as viewed from the
front
Hole drilled
at angle 30.0
Hole drilled
at angle 0.0