Nidek Medical Le 1000, Service Manual

Page: 99 / 152

LLE14BRDA001A/E
7 - 35
7.5.6 Torque calibration of tracing unit
Purpose: Performing torque calibration of the tracing unit
1. While pressing and
4
simultaneously,
turn on the power.
2. After confirming the LED of blinks, open
fully the sliders of the tracing unit by hand.
3. Press .
* After the torque calibration is completed,
perform the frame auto calibration (see
7.5.7).
7.5.7 Frame auto calibration of tracing unit
Purpose: Performing frame calibration of the tracing unit using the 45 standard frame jig
Jig: 45 standard frame jig LEDJ-10(40390-M301)
1. Set the 45 standard frame jig (40390-M301).
2. Press
4
while pressing .
3. After confirming the LED of blinks, press
.
7.5.8 Pattern auto calibration of tracing unit
Purpose: Performing pattern calibration of the tracing unit using the 45 standard pattern jig
Jig: 45 standard pattern jig LEDJ-6 (41476-M002)
1. Attach the 45 standard pattern jig (41476-
M002) to the pattern setting unit as shown to
the right.
* Be sure to use the provided pattern setting
unit.
2. Press
4
while pressing .
(40390-M301)
-0010
40372
(41476-M002)