5
Pressure range
102R
103R
102A
Rated pressure［kPa］
−100.0〜100.0
−100〜1000
0.0〜100.0 ※
Output voltage ［V］
−1.000〜1.000
−0.100〜1.000
0.000〜1.000
※Unit：kPa abs.
Top view
Protect cover
LOBAT
MkPa
bar
HOLD
psi
O.SET
in.mmHgAq
LIQUID TYPE
HANDY MANOMETER
COPAL ELECTRONICS
MODE
ZERO
SET UP
HOLD
POWER
6 1
Connector
Manufacturer
JST Mfg. Co., Ltd.
Housing
ZHR-6
Contact
SZH-002T-P0.5
SZH-003T-P0.5
Wire gauge
AWG28〜26
AWG32〜28
Connector No.
１
２
３
４
５
６
Description
External power input （5V）
Analog output terminal （±1V）
GND
CAL
CAL
CAL
Analog Function
Attachment of protect cover
Open the battery cover on the back of the main body and insert the pre-wired connector according to the table shown below. After applying external power,
press the POWER button to turn on the power. Be sure to use the product with the batteries removed. The mode will not switch to the analog output
mode unless the batteries are removed.
Analog voltage as indicated will be output to the analog output terminal.
Pressure range, rated pressure and output voltage are shown to the table below.
No voltage or signal should be applied to the CAL terminal since it is for adjustment use only.
Failure to heed this warning may result in product malfunction or damage to the main body.
Please attach the protect cover to the main body from top
side（the side of pressure port）to the end completely. Be
careful about the front side of the cover. Strap canʼt be
attached with the protect cover on the main body.
Periodical Calibration
If you would like to calibration request, please contact the sales office where you purchased.
Warranty
The warranty period for the product shall be one year. A failure due to causes attributed to design or manufacturing defects during the period one year
from the date of delivery shall be repaired or replaced free of charge. However, the term “warranty” herein referred to shall imply the warranty for the
product unit only, and damages from failure of the product shall be excluded. The following shall be excluded from the warranty:
⑴ Failure or damage caused by improper use and careless operation in violation of the Operating Instructions.
⑵ Failure or damage caused by inappropriate modification, adjustment, or repair.
⑶ Failure or damage caused by acts of God, fire, or other unavoidable accidents.
⑷ Replacement of accessories (cables, etc.) and supplies that come with the product.
[Note]
Copying or reprinting the entire or part of the Operating Instructions shall be prohibited except where exceptions to copyright laws apply. Furthermore,
descriptions stated in the Operating Instructions are subject to change without prior notice.
