32
PARAMETER-SETTING INTERFACE AND OPTIONS
POWERDRIVE MD2CS Installation guide
4946 - 2017.12 / c
en
5.1.2 - MDX-Powerscreen
• General
The POWERSCREEN interface is a touch screen which can
be used to access various menus to setup and supervise the
drive.
After the loading phase following the power-up of the drive,
the parameter-setting interface displays the screen below in
french. Select language using the "F" buttons below
COM
CPU
PWR
F
C
D
E
A
B
Ref.
Function
A
4.3" touch screen
B
Touch-sensitive button to access the main menu
C
"COM" LED, indicates the state of the communication
with the drive.
Off: no communication
Flashing: communicating
D
"CPU" LED, indicates the status of the interface CPU
E
"PWR" LED, indicates the state of the interface power
supply
F
Touch-sensitive buttons for language selection (can take
a few minutes to load)
• Installation
The interface is flush-mounted in the front of a cabinet (IP65/
NEMA 4 mounting). It is fixed by 4 screws (tightening 2 Nm).
Cut-out drawing
93 mm
102 mm
119 mm
128 mm
5 - PARAMETER-SETTING INTERFACE AND OPTIONS
5.1 - Optionnal Parameter setting
interfaces
5.1.1 - Location of the drive connectors / ports
Px1
Px2
Px3
P1 P2
1
1
1
Connector for optional
fieldbus and/or
speed feeback
Connector for
MDX-KEYPAD or
MDX-Powerscreen display
USB connector linked
to door USB socket
◦ P1 connector
This connector is a slave type B USB connector linked to door
USB socket, and is used to communicate via PC using the
MDX-SOFT software.
In conformity with standard EN 60950, the USB link
can only be used via a device that provides
isolation of 4 kV (MDX-USB isolator option).
◦ P2 terminal block
This is a standard RS485/RS422 terminal block which is used
to connect a parameter-setting interface (MDX Powerscreen,
MDX Keypad) or to communicate via Modbus RTU.
Terminals
Description
1
0V
2
Rx\, Tx\
3
Rx, Tx
4
24V
Check that control circuits are powered down
before disconnecting the programming interface
from the P2 connector.
