![background image](http://html1.mh-extra.com/html/nidec/digitax-hd-m75x-series/digitax-hd-m75x-series_quick-start-manual_1687791010.webp)
10
Digitax HD M75X Quick Start Guide
Issue Number: 2
2
Mechanical installation
Figure 2-1 M75X dimensions (Frame 2 shown)
* Cut outs only required for rear venting, refer to the
Digitax HD M75X Series Installation and
Technical Guide
for further information.
Table 2-1 Dimensions by frame size (refer to Figure 2-1)
* For single axis stand alone drives, two M5 screws are required in the top mounting position and
one in the lower mounting position. For multi axis (side by side installation) with no DIN rail
attachment, one M5 screw is required in the top mounting position and one in the lower mounting
position for each drive. For multi axis (side by side installation) with DIN rail attachment one M5
screw in the top mounting position is sufficient to fix the drive to the back plate.
** 62 mm (2.44 in) with option module support installed.
•
All frame sizes require a minimum clearance of 100 mm (3.94 in) above and below the product.
•
A minimum clearance of 10 mm (0.39 in) should be maintained between the enclosure side
wall and the drive.
Drives may be mounted side by side (0 mm). For further information on mechanical installation
refer to the
Digitax HD M75X Series Installation and Technical Guide
.
Frame size
H
W**
D
M1
M2 (Ø)*
mm
in
mm
in
mm
in
mm
in
mm
in
1
233
9.17
40
1.58
174
6.85
222
8.74
5.2
0.21
2
278
10.95
40
1.58
174
6.85
267
10.51
5.2
0.21
3
328
12.91
40
1.58
174
6.85
317
12.48
5.2
0.21
12 mm
(0.47 in)
5 mm
(0.20 in)
Ø 32 mm
(1.26 in)
*
40 mm (1.58 in)
6 mm
(0.24 in)
28 mm
(1.10 in)
35 mm
(1.38 in)
W
M2
M2
M2
M1
H
D
NOTE