Nidec DFS 1, Power Installation Manual

Page: 21 / 61

DFS1/DFS2 Power Installation Guide
21
Issue Number: 2
Safety i
nform
ation
Produ
ct in
fo
rm
ation
Mech
an
ical
in
st
all
at
ion
Electrica
l inst
alla
tion
Te
chn
ical
d
ata
3.1.1 Lifting and Handling
The information in this section is also provided on a laminated sheet fixed to the outside of the
enclosure. It is intended to be read by the personnel responsible for lifting, handling and transporting
the drive.
Figure 3-1 Lifting the cubicle
The maximum weight of the cubicles are shown in Table 3-1.
Table 3-1 Maximum cubicle weight
Lifting and handling
Always lift the drive by the lifting lugs.
The drives are not supplied with lifting lugs. These must be fitted to the top of the enclosure
by the installer.
Insert shackles into the eye bolts. Ensure that the angle of each lifting rope is greater than
45°, as shown in Figure 3-1.
The cubicle is disproportionally heavy at the top and must be properly secured to prevent
it from overbalancing and falling during installation.
When transporting the equipment by fork lift truck, place the cubicle on a rigid pallet and
secure it in place.
Multiple bayed enclosures cannot be transported this way.
Size Model kg lb
DFS1 All variants 300 661
DFS2 All variants 720 1587
NOTE
WARNING
Use the lifting eyebolts attached
to the top of the enclosure
Arrow indicates the lifting point/
direction of the enclosure
Insert the shackles into the
eyebolts. Ensure the angle of
each lifting rope is ≥ 45°
WARNING