Nice Apollo 4300 SW, User Manual

Page: 27 / 32

25
This procedure allows slight mechanical adjustment of the gate’s closing angle by extending or retracting the main arm.
1. Using a 2.5mm or 3/32 hex key, turn the locking bolt on the side of the arm counter-clockwise to release the adjustment knob.
2. Rotate the knob as shown to increase or decrease the length of the main arm. NOTE: Do not extend the main arm more than 2"!
3. Using a 2.5mm or 3/32 hex key, turn the locking bolt on the side of the arm clockwise to lock the adjustment knob in place.
27 - APOLLO GATE OPENER TROUBLESHOOTING
POSSIBLE SOLUTION
Check that power to the operator is turned ON
Check terminal block wiring for loose or broken wires
Check for 115 VAC at source. If voltage measures OK, check the terminal block
Check the fuse
Check the UL/Edge input on the gate controller
Adjust Force Settings
Check the input LEDs. Any ON will hold the gate open and indicates a problem with a keying device
Check the secondary safety devices. Any activated safety device will hold the gate open and indicates a
problem with the safety device
Check the loop detectors. Any activated safety device can hold the gate open and indicates a problem with
the loop detector or ground loop
Check if backup system is set to open gate automatically or requires an input to open
Check the batteries for proper voltage. Replace if necessary
Clear any obstructions from the path of the gate. Press RESET to clear (or hard reset button)
Check accessory inputs and clear then as necessary
SYMPTOM(S)
Operator will not Power On.
Power LED is OFF
Gate opens a short distance, then
stops and reverses
Gate opens but will not close
Battery backup system will not open
gate upon AC power outage
Hard Shutdown (2 back to back
obstructions) LED blinking, Buzzer
sounds for 5 minutes
Gate opens by itself
Table 3
26 - MECHANICAL ADJUSTMENT OF GATE CLOSING POSITION
1
2
3
21" MINIMUM
WIDTH
DIMENSION
Figure 35 - COMPACT INSTALLATION